Write You
#1 in Business Subscribe Email Print

You are here: Home > Business > Business > Concrete and Masonry Work: OSHA's Top Violations

Tags

  • protect
  • corporations
  • brace
  • those employees

  • Links

  • Refinancing a Mortgage at the Best Time Possible
  • Pre Flop Pot Limit Omaha Poker Strategy
  • The Zone of Enjoyment
  • Write You - Concrete and Masonry Work: OSHA's Top Violations

    Online Advertising For The Chinese Market
    When you need to get your products or services in front of a Chinese audience, where do you start? This article will give you some tips.Whether you have a full line of products and services available that you want to market to China, or whether you only have one or two things available to China residents, you'll want to get your website in front of Chinese eyes through online advertising methods with a Chinese twist.
    are not to enter the zone (area). The zone must be equal to the length of the wall to be constructed and extended out (from the wall’s base) a distance equal to the height of the wall to be constructed plus 4 feet. Therefore, if the wall to be constructed is 8 feet high and 40 feet long, the zone should be 12 feet x 40 feet.

    3) Failure to brace unsupported section of masonry wall ov

    Are Corporations Doomed to Fail?
    Many people believe that the Public Mega Corporations are eventually doomed to fail and of course there are many reasons for this. One of the most common reasons cited by media is Corporate Malfeasance. Another one which some free-market economists note is that the Stock Market is now a gambling casino and still others make light of the fact that corporate greed from those at the top is out of control. Of course someone once sa
    What are the most frequently cited serious violations of the concrete and masonry standard? The following are OSHA’s top four followed by suggestions and protective measures you can use to make your jobsites safe.

    1) Failure to protect employees from impalement - rebar not capped or covered. Make sure that all rebar is capped/covered with an approved protective device designed for this purpose such as the hard plastic mushroom type caps which are designed to fit various sizes of rebar. Plastic or paper cups, orange traffic cones or tape are not acceptable means of protection. Prevent or limit your employees from working in areas where they could fall into or onto rebar. If this is not possible, limit employee exposure to these areas by use of guardrails or other fall protection measures as outlined in Subpart M. Rebar can be bent as a protective measure, however this practice must be approved by an engineer, or the rebar can be covered with lumber (e.g., a 2 x 4 board).

    2`) Failure to establish a limited access zone to limit the number of workers in the danger zone where a masonry wall is under construction. The limited access zone (danger zone) is established to protect employees (in the immediate vicinity of new wall construction) from being struck by flying/falling brick and block in the event of a wall collapse. Only those employees actually engaged in constructing the wall should be within this area. This area must be marked off by means of a chain, rope, tape, or other material that will indicate to employees that they are not to enter the zone (area). The zone must be equal to the length of the wall to be constructed and extended out (from the wall’s base) a distance equal to the height of the wall to be constructed plus 4 feet. Therefore, if the wall to be constructed is 8 feet high and 40 feet long, the zone should be 12 feet x 40 feet.

    3) Failure to brace unsupported section of masonry wall ove

    Make Your Business Successful: Be More Effective And Drop The Bone
    Success is what you want for you and your business, isn't it? Although success means different things to different people, there are some ingredients that are necessary to have in the mix. One of the most important ingredients is being effective as a businessperson. So, whether your business is small or large, new or growing, you need to be effective.Being effective is doing the ‘right’ things well. Now, it’s simpl
    this purpose such as the hard plastic mushroom type caps which are designed to fit various sizes of rebar. Plastic or paper cups, orange traffic cones or tape are not acceptable means of protection. Prevent or limit your employees from working in areas where they could fall into or onto rebar. If this is not possible, limit employee exposure to these areas by use of guardrails or other fall protection measures as outlined in Subpart M. Rebar can be bent as a protective measure, however this practice must be approved by an engineer, or the rebar can be covered with lumber (e.g., a 2 x 4 board).

    2`) Failure to establish a limited access zone to limit the number of workers in the danger zone where a masonry wall is under construction. The limited access zone (danger zone) is established to protect employees (in the immediate vicinity of new wall construction) from being struck by flying/falling brick and block in the event of a wall collapse. Only those employees actually engaged in constructing the wall should be within this area. This area must be marked off by means of a chain, rope, tape, or other material that will indicate to employees that they are not to enter the zone (area). The zone must be equal to the length of the wall to be constructed and extended out (from the wall’s base) a distance equal to the height of the wall to be constructed plus 4 feet. Therefore, if the wall to be constructed is 8 feet high and 40 feet long, the zone should be 12 feet x 40 feet.

    3) Failure to brace unsupported section of masonry wall ov

    Three Easier-Than-We-Make-'Em Steps to Success in Life and Business
    Advice.Aren't you just sick of it already?Everyone wants you to succeed in achieving the life and business of your dreams, and they all claim to have the key to getting there.Only problem is, everyone's advice is different.Melanie 'The Entrepreneur's Success Coach' Strick says you need to create Unstoppable Goals.Adam 'The Marketing Mentor' Urbanski says you need a marketing action plan.all protection measures as outlined in Subpart M. Rebar can be bent as a protective measure, however this practice must be approved by an engineer, or the rebar can be covered with lumber (e.g., a 2 x 4 board).

    2`) Failure to establish a limited access zone to limit the number of workers in the danger zone where a masonry wall is under construction. The limited access zone (danger zone) is established to protect employees (in the immediate vicinity of new wall construction) from being struck by flying/falling brick and block in the event of a wall collapse. Only those employees actually engaged in constructing the wall should be within this area. This area must be marked off by means of a chain, rope, tape, or other material that will indicate to employees that they are not to enter the zone (area). The zone must be equal to the length of the wall to be constructed and extended out (from the wall’s base) a distance equal to the height of the wall to be constructed plus 4 feet. Therefore, if the wall to be constructed is 8 feet high and 40 feet long, the zone should be 12 feet x 40 feet.

    3) Failure to brace unsupported section of masonry wall ov

    Benefits of Customized Business Forms
    Business involves a lot of commitments and handling them perfectly is an art. The key to open the success of any business lock is possible only if one has the right sources. Business forms play a major role in an organization. Customized business forms are an adapted set of forms required to run an organization. Customized business forms usually consume more time than the standard business forms, as they are perfect with inform
    ne) is established to protect employees (in the immediate vicinity of new wall construction) from being struck by flying/falling brick and block in the event of a wall collapse. Only those employees actually engaged in constructing the wall should be within this area. This area must be marked off by means of a chain, rope, tape, or other material that will indicate to employees that they are not to enter the zone (area). The zone must be equal to the length of the wall to be constructed and extended out (from the wall’s base) a distance equal to the height of the wall to be constructed plus 4 feet. Therefore, if the wall to be constructed is 8 feet high and 40 feet long, the zone should be 12 feet x 40 feet.

    3) Failure to brace unsupported section of masonry wall ov

    Internet Millions
    Internet millions - Is it possible to make 1000's of dollars working from home with only a computer and an Internet connection. Yes, I think anybody could if they really wanted to. When I say really want to I mean you have to have a desire to make money. And everybody that starts there own business usually have a very strong desire to start with but after a while it fades away and you forget WHY you started this business. If
    are not to enter the zone (area). The zone must be equal to the length of the wall to be constructed and extended out (from the wall’s base) a distance equal to the height of the wall to be constructed plus 4 feet. Therefore, if the wall to be constructed is 8 feet high and 40 feet long, the zone should be 12 feet x 40 feet.

    3) Failure to brace unsupported section of masonry wall over 8 feet in height. A new masonry wall over 8 feet in height should be braced to protect against the hazard of collapse. The project engineer or competent person should determine how best to brace the wall. A typical masonry wall brace will include a vertical member, an inclined strut, stakes, and if necessary a strut brace. 2 x 10 scaffold planks are typically used as the vertical members and the inclined strut and 2 x 4s for stakes and strut braces. 2 x 4s and 2x 6s are inadequate for vertical members or inclined struts. All lumber used must be in serviceable condition. Finally, The American National Standards Institute (ANSI) recommends that the support or bracing be designed and/or performed under the supervision of a “qualified person” to withstand (at a minimum) 15 pounds per square foot and those strong winds need to be considered.

    4) Failure to have the drawings or plans at the jobsite that indicate the jack layout and formwork placement. Make sure that a copy of the formwork drawings and plans are maintained at the jobsite for review by the employer, employees, and OSHA compliance personnel. Your formwork must be installed as shown on your drawings and/or plans.

    For more information on custom written construction safety programs / manuals, safety training, and discrete contractor safety programs / manuals please contact Vic Sunshine at Omni Safety Services (www.omnisafety.com)

    HTTP = HTML link (for blogs, profiles,phorums):
    <a href="http://www.writeyou.net/article/2616/writeyou-Concrete-and-Masonry-Work--OSHAs-Top-Violations.html">Concrete and Masonry Work: OSHA's Top Violations</a>

    BB link (for phorums):
    [url=http://www.writeyou.net/article/2616/writeyou-Concrete-and-Masonry-Work--OSHAs-Top-Violations.html]Concrete and Masonry Work: OSHA's Top Violations[/url]

    Related Articles:

    Incorporate Your Business For Great Business Benefits

    Natural Dyes

    India Invests $1 Billion in Global Trade Deal with Africa

    Bookmark it: del.icio.us digg.com reddit.com netvouz.com google.com yahoo.com technorati.com furl.net bloglines.com socialdust.com ma.gnolia.com newsvine.com slashdot.org simpy.com shadows.com blinklist.com


    hotel bydgoszcz Fajne filmy obrazy minikoparki hotele w barcelonie