| Write You |
Hubs | Hubbers | Topics | Request |
| #1 in Business | Subscribe Email Print |
|
You are here: Home > Automotive > Motorcycles > Checking and Charging Motorcycle Batteries |
|
Write You - Checking and Charging Motorcycle Batteries
A Sunroom Makes An Excellent Home Improvement Project Due To Their Rising Popularity is at the upper level, and don’t fill the cells up to the very top of the battery.It is estimated that over half-a-million Americans are building sunrooms each year, with the rooms being used for a variety of functions. Sunrooms have a lot of windows. These room are designed to get a maximum amount of sunlight. The term Sunrooms, solariums or garden rooms are synonymous.Sunrooms have universal appeal and can be added to almost any 4. You can either use an optimizer on the battery which can effectively switch off the battery when it’s charged and prevents overheating, or disconnect it manually. 5. It is recommended to put your battery on charge every two or three weeks. 6. An upper and lower level battery should have all the cells on the upper level, not over and never under the lower level. 7. For topping off the low cells, use only distilled water. 8. The minimum ch Easing Back into Workouts After Time Off How are Motorcycle Batteries Rated?I tend to work out in spurts... I work out really hard for a few weeks and then I tend to slack off for a while. Recently, I decided I needed to get back into better shape again (for ski season) and started doing some very brief kettlebell workouts.I was interested mainly in trying some different ways to help reduce my lower back pain and scoliosis, and I de The amp/hour (AH) capacity is the basis for rating motorcycle batteries. For example, a 12AH battery can produce one amp of current flow for 12 hours, or two amps for six hours. In order to calculate the amount of time needed to use up a fully charged motorcycle battery by turning the lights on, we have to take power in watts, and divide it by voltage, which gives us the current draw in Amps. Therefore, a 72 watts beam and tail together, divided by 12 volts equals a 6-amp draw. So in 2 hours, the 12AH battery is dead. Checking Motorcycle Battery: If you decide to check if your new motorcycle battery is done correctly, follow this actual factory-recommended service procedure. If the battery is not a maintenance-free type which doesn't have a vent tube, unwrap the battery, unkink the vent tube and snip about a half-inch off the end. Fill it with electrolyte midway (between the high and low level markings on the case) and leave it undisturbed for one or two hours. Remember, the battery will still be at only 65% of full charge at this point. Add electrolyte again if required. If your battery is a refillable lead-antimony type, it should be charged at one-third of its rated capacity in amp/hours for four to five hours to get it to full charge. Maintenance-free type battery should be charged with a constant-current charger that can drive the charge with as much as 16.9 volts. This should be closely supervised so as not to exceed full charge. Next, recheck the electrolyte level and add water if required. Let the battery cool so the case contracts enough to fit into its typically tight little holder. Run the new breather tube, if the battery comes along with one, carefully through the original factory routing. Things to Remember when Charging the Battery: 1. First of all, it is important to remember that Red is positive and Black is negative in order to avoid any accidents such as short-circuits and nasty shocks. 2. The charger should be compatible with the motorcycle battery, and give a greater output than the battery voltage but not too high. 3. Make sure the connections are clean and the electrolyte is at the upper level, and don’t fill the cells up to the very top of the battery. 4. You can either use an optimizer on the battery which can effectively switch off the battery when it’s charged and prevents overheating, or disconnect it manually. 5. It is recommended to put your battery on charge every two or three weeks. 6. An upper and lower level battery should have all the cells on the upper level, not over and never under the lower level. 7. For topping off the low cells, use only distilled water. 8. The minimum cha Project Managers and Technical Writers: The Outsiders that Make Tech Work is dead.Project managers need to create plans, form teams and keep track of all of the challenges and deadlines that are part of today's fast paced product development cycle. They stand in the center of a crowd of different people, and have to unite and guide them towards a specific goal.The irony of project management is that while managers have a hand in everythin Checking Motorcycle Battery: If you decide to check if your new motorcycle battery is done correctly, follow this actual factory-recommended service procedure. If the battery is not a maintenance-free type which doesn't have a vent tube, unwrap the battery, unkink the vent tube and snip about a half-inch off the end. Fill it with electrolyte midway (between the high and low level markings on the case) and leave it undisturbed for one or two hours. Remember, the battery will still be at only 65% of full charge at this point. Add electrolyte again if required. If your battery is a refillable lead-antimony type, it should be charged at one-third of its rated capacity in amp/hours for four to five hours to get it to full charge. Maintenance-free type battery should be charged with a constant-current charger that can drive the charge with as much as 16.9 volts. This should be closely supervised so as not to exceed full charge. Next, recheck the electrolyte level and add water if required. Let the battery cool so the case contracts enough to fit into its typically tight little holder. Run the new breather tube, if the battery comes along with one, carefully through the original factory routing. Things to Remember when Charging the Battery: 1. First of all, it is important to remember that Red is positive and Black is negative in order to avoid any accidents such as short-circuits and nasty shocks. 2. The charger should be compatible with the motorcycle battery, and give a greater output than the battery voltage but not too high. 3. Make sure the connections are clean and the electrolyte is at the upper level, and don’t fill the cells up to the very top of the battery. 4. You can either use an optimizer on the battery which can effectively switch off the battery when it’s charged and prevents overheating, or disconnect it manually. 5. It is recommended to put your battery on charge every two or three weeks. 6. An upper and lower level battery should have all the cells on the upper level, not over and never under the lower level. 7. For topping off the low cells, use only distilled water. 8. The minimum ch The Benefits Of A Foot Massage Add electrolyte again if required.A foot massage is something that almost everyone craves, but very few can actually get. It can be both sensual as well as relaxing. This is a very simple idea that can help to keep even the most on edge person relaxed and at ease. A simple foot massage can relieve many of the tensions of the day and can make you feel revitalized. It can do this in many different If your battery is a refillable lead-antimony type, it should be charged at one-third of its rated capacity in amp/hours for four to five hours to get it to full charge. Maintenance-free type battery should be charged with a constant-current charger that can drive the charge with as much as 16.9 volts. This should be closely supervised so as not to exceed full charge. Next, recheck the electrolyte level and add water if required. Let the battery cool so the case contracts enough to fit into its typically tight little holder. Run the new breather tube, if the battery comes along with one, carefully through the original factory routing. Things to Remember when Charging the Battery: 1. First of all, it is important to remember that Red is positive and Black is negative in order to avoid any accidents such as short-circuits and nasty shocks. 2. The charger should be compatible with the motorcycle battery, and give a greater output than the battery voltage but not too high. 3. Make sure the connections are clean and the electrolyte is at the upper level, and don’t fill the cells up to the very top of the battery. 4. You can either use an optimizer on the battery which can effectively switch off the battery when it’s charged and prevents overheating, or disconnect it manually. 5. It is recommended to put your battery on charge every two or three weeks. 6. An upper and lower level battery should have all the cells on the upper level, not over and never under the lower level. 7. For topping off the low cells, use only distilled water. 8. The minimum ch Email Subscribers Want More Control tight little holder. Run the new breather tube, if the battery comes along with one, carefully through the original factory routing.The broad survey found that subscribers are still interested in receiving email offers and e-newsletters, which is surprising considering the continual drop in email open rates, but in exchange, subscribers want control over what they receive from senders and when they receive it.The Internet has become more of a participatory medium, and email users are exp Things to Remember when Charging the Battery: 1. First of all, it is important to remember that Red is positive and Black is negative in order to avoid any accidents such as short-circuits and nasty shocks. 2. The charger should be compatible with the motorcycle battery, and give a greater output than the battery voltage but not too high. 3. Make sure the connections are clean and the electrolyte is at the upper level, and don’t fill the cells up to the very top of the battery. 4. You can either use an optimizer on the battery which can effectively switch off the battery when it’s charged and prevents overheating, or disconnect it manually. 5. It is recommended to put your battery on charge every two or three weeks. 6. An upper and lower level battery should have all the cells on the upper level, not over and never under the lower level. 7. For topping off the low cells, use only distilled water. 8. The minimum ch Having Quality Links Can Allow You To Profit is at the upper level, and don’t fill the cells up to the very top of the battery.Search engines like Google earn their money by placing advertisements next to the search results in their engines. If these results become easy to alter, the efficiency of the search engine will decline, and people will begin using other search engines to find important data. If this happens, there is no point in selling ad space. To solve this problem, Google has 4. You can either use an optimizer on the battery which can effectively switch off the battery when it’s charged and prevents overheating, or disconnect it manually. 5. It is recommended to put your battery on charge every two or three weeks. 6. An upper and lower level battery should have all the cells on the upper level, not over and never under the lower level. 7. For topping off the low cells, use only distilled water. 8. The minimum charge for a new batter should be at least for 8 hours. 9. If you have a dry battery, fill the cells slowly and leave the battery for around half an hour.
HTTP = HTML link (for blogs, profiles,phorums):
Related Articles:Exercising to Improve Your Sleep Things To Avoid Before Buying A Car
|